GRAPHTEC LABELROBO LCX603 - Parts Names and Functions

LCX603-UM-651-9370 2-11
2 Setup
2.6 Parts Names and Functions
Part Names 1
Control panel
Label tray
Outlet
Cross cutter unit
Laminate stocker
Separator
winder bobbin
Separator
Dancer roller 1
Press roller
Feed roller
Laminate bar
Cutter unit
Press lever
Laminate winder bobbin
Dancer roller 2
Control panel................................Carryoutoperationsandvarioussettings.
Separator......................................Setwhenunnecessarymediaisdetached.
Separator winder bobbin............Rollsupdetachedunnecessarymedia.
Press lever....................................Opensandclosesthepressrollerwhenthemediaisset.
Laminate bar.................................Usedwhenlaminateisset.
Laminate winder bobbin.............Rollsupthelaminatebackingsheet.
Laminate stocker.........................Setsthelaminate.
Feed roller.....................................Feedsthemedia.
Press roller...................................Thruststhemediaintothefeedroller.
Dancer roller (1, 2)........................Usedwhensetting/feedingmedia.
Cutter unit.....................................Cuts(stenciling,frame-cutting)media.
Label tray......................................Traythatreceivescompletedlabels.
Cross cutter unit..........................Cutterusedforcross-cutting(horizontalcutting)media.
Outlet.............................................Sectionthatoutputsmedia.