GRAPHTEC LABELROBO LCX603 - Cross Cutter Setting

LCX603-UM-651-9370 2-80
2 Setup
2.21 Cross cutter setting
Whenthecrosscutfunctionisusedsetthisfunctionto"ON".
TheDefaultsettingis“ON”.
Themediaiscutatexitareawhenthisfunctionissetto"ON".
Caution of using the cross cutter
Crosscutisforcuttoonlythebackingpartofmedia.Theseparatorfunctionshouldbeusedwhenthe
crosscutfunctionisusing.
Theremaybeuncutmaterialsifyoutrytocutmediabybackingsheetorwithattachedlaminatematerials.
Also,thecrosscutsectionmightbedamagediftheglueofmediaattachestotheblade.Donotcut
anythingotherthanthebackingsheet.
Thelifespanofacrosscutcutterbladeisapproximately10,000times.
How to set the cross cutter function
(1) PresstheLOCALKeyinREADYstatus,thefollowingmenuisdisplayed.
PR I N TER M ENU>
C U T TER M ENU>
O U TPU T ALL>
(2) PresstheF1Key(PRINTMENU),thefollowingmenuisdisplayed.
C OPY>
D A TA C L EAR>
C OND I T ION>
1/4
(3) PresstheNEXTKeyuntilthefollowingmenuisdisplayed.
RE G ISTR A T ION M ARK>
U N I T L E N GTH>
F U NCTI O N SE T T ING>
3/4
(4) PresstheF3Key(FUNCTIONSETTING),thefollowingmenuisdisplayed.
LAM I N ATE>
S EPA R A TOR>
C ROS S CUT>
F RAM E CUT>
(5) PresstheF3Key(CROSSCUT),thefollowingmenuisdisplayed.
CROS S CUT S ETT I N G
<ON>
SELE C T:
↑ ↓
YES: E NTER N O :ESC