GRAPHTEC LABELROBO LCX603 - Test Printing and Density Adjustment

LCX603-UM-651-9370 2-50
2 Setup
2.15 Test Printing and Density Adjustment
Conrmthe130mmwidthofmediaisinstalledtotheLCX603.
Conrmtheinkribbonsareinstallingtotheallribboncassettes.
Thetestprintingwillnotbeperformedcorrectlyifabovemediaandribbonsarenotinstalled.
Thefollowingtestpatternisprintedwhenthetestprintisperformed.
Test printing pattern
Y
X
Feeding direction
Head 3 (Ribbon 3)
Head 1 (Ribbon 1)
Head 1 (Ribbon 1)
Head 2 (Ribbon 2)
Head 2 (Ribbon 2)
Head 3 (Ribbon 3)
How to print the test printing pattern
(1) PresstheLOCALKey,thefollowingmenuisdisplayed.
PR I N TER M ENU>
C U T TER M ENU>
O U TPU T ALL>
(2) PresstheF1Key(PRINTMENU),thefollowingmenuisdisplayed.
C OPY>
D A TA C L EAR>
C OND I T ION>
1/4
(3) PresstheNEXTKeyuntilthefollowingmenuisdisplayed.
PRI N T SE T T ING>
PRI N T TE S T PA T T ERN>
H EAD A D JUS T M ENT>
2/4 PRIN T E D L E N GTH>
(4) PresstheF2Key(PRINTTESTPATTERN),thefollowingmenuisdisplayed.
PRI N T TE S T PA T T ERN>
ADJU S T P& C POS I T ION>