GRAPHTEC LABELROBO LCX603 - Setting the Anti-Wrinkle Line

LCX603-UM-651-9370 2-87
2 Setup
2.23 Setting the Anti-Wrinkle Line
Setwhethertoprinttheanti-wrinklelinesornot.
WhensettoON,alineabout1.3mmwideisprintedoutsidetheprintingareainthedirectionofthewidth
ofthemediaprintingdata,andwrinklingisprevented.
Typically,usethisdevicewiththelinesprinted(ON).
Whenshippedfromthefactory,thedeviceissettoON.
Whenthebalanceoftheprintdatapositionispoor,wrinklesoccurontheribbonduringprinting,andthere
arecaseswherethishasaneffectontheprintingresult.Inacasesuchasthis,settoON.
Whennotnecessaryusethisanti-wrinklelines,setthissettingtoOFF.(Ifprintinggoodbalanceofprinting
data.)
Feeding direction
Anti wrinkle lines
How to set the anti-wrinkle lines function
(1) PresstheLOCALKeyinREADYstatus,thefollowingmenuisdisplayed.
PR I N TER M ENU>
C U T TER M ENU>
O U TPU T ALL>
(2) PresstheF1Key(PRINTMENU),thefollowingmenuisdisplayed.
C OPY>
D A TA C L EAR>
C OND I T ION>
1/4
(3) PresstheNEXTKeyuntilthefollowingmenuisdisplayed.
PRI N T SE T T ING>
PRI N T TE S T PA T T ERN>
H EAD A D JUS T M ENT>
2/4 PRIN T E D L E N GTH>
(4) PresstheF1Key(PRINTSETTING),thefollowingmenuisdisplayed.
PRI N T DE N S ITY>
P AGE P R INT M ODE>
ANT I -WRI N K LE L I NES>