GRAPHTEC LABELROBO LCX603 - Turning on the Power

LCX603-UM-651-9370 2-22
2 Setup
2.10 Turning on the power
(1) TurnthepowerswitchtotheOn(I)position.Afterinitialoperations,thecontrolpanel'sREADYlamp
willlightup.
(2) Ifthemediaisnotinstalled,thefollowingmessagewilldisplayaftershowingtheversion.
L01: No M e d ia
Set the M e dia i nto
stoc k er.
Then pres s FEE D key.
InstallthemediatotheLCX603.
Ifthemediaisinstalled,thefollowingmessagewilldisplayaftershowingtheversion.
Con r m Co m b ina t i on!
H3=S e mi-R H2= R E SIN
H1=R E SIN
YES: E NTER N O : ESC
(3) ConrmthecombinationofinkribbonsthatareinstallingtotheLCX603.
PresstheENTERKeyifthecombinationiscorrect.
Afterinitializationwasnished,followingmenuisdisplayed.
READ Y
C ONDI T I ON- 0 1
PresstheESCKeyifthecombinationisnotcorrect.Thefollowingmenuisdisplayed.
C ondi t i on L O AD>
PRIN T DEN S I TY>
(4) Setthedensityfortheheads.