GRAPHTEC LABELROBO LCX603 - How to Take out the LCX603 from the Packing Box

LCX603-UM-651-9370 2-1
2 Setup
2 Setup
2.1 How to take out the LCX603 from the Packing Box
TheLCX603ispackedbythewoodyboxasshowninthepicturebelow.
FollowtheproceduretotakeouttheLCX603fromthepackingbox.
 WhenunpackingtheLCX603fromwoodybox,makesuretherearetwopeopletocarryout
thetask.
How to take out the LCX603 from the packing box
(1) Removetheselftappingscrewswhicharemarkingbytheredcircleholdingthetoppanel.
Removetheselftappingscrews
whicharemarkingbytheredcircle.
Selftappingscrew Selftappingscrew