GRAPHTEC LABELROBO LCX603 - Adjusting Printing and Cutting Position

LCX603-UM-651-9370 2-59
2 Setup
2.17 Adjusting printing and cutting position
Whenthereisashiftinthecutpositionandthecuttersectionregistrationmarkreadingsensor,itis
possibletocompensatebyenteringacorrectionvalue.
InprintingwithHead3(ribbon3),theregistrationmarkreadingsensorandthetoolholderpositionare
adjusted.
Firstprinttheadjustmentpattern,thencutwiththecutterattachedinthetoolholderastheregistration
markstandard.
Print and Cut Adjustment Pattern Instructions
Feeding direction
Printed cross (+): Ribbon 3 Registration markStart mark
Page 1 Page 5
Cut cross (+)
Three registration marks are printed in one page.
How to adjust the printing and the cutting position
The5pageofadjustmentpatternswillbeprinted,andthentheLCX603willscanthestartmarkandthe
registrationmarks.TheLCX603cutsthecrossontheprintedcrosspatternaccordingbytheregistration
marks.Thenadjustthepositionbetweentheprintedcrosspatternandthecutcross.
(1) PresstheLOCALKeyinREADYstatus,thefollowingmenuisdisplayed.
PR I N TER M ENU>
C U T TER M ENU>
O U TPU T ALL>
(2) PresstheF1Key(PRINTMENU),thefollowingmenuisdisplayed.
C OPY>
D A TA C L EAR>
C OND I T ION>
1/4
(3) PresstheNEXTKeyuntilthefollowingmenuisdisplayed.
PRI N T SE T T ING>
PRI N T TE S T PA T T ERN>
H EAD A D JUS T M ENT>
2/4 PRIN T E D L E N GTH>