GRAPHTEC LABELROBO LCX603 - Page 66

LCX603-UM-651-9370 2-58
2 Setup
(4) Performacheckofthecutpattern.Peelthesquaresectionofthetestpatternexteriorandobserve
thetriangularcornersectioninthemiddle.Ifthecornersectionsareround,thecorrectionamount
(offset)islacking.Bycontrast,iftherearesharpwhisker-likeareasinthecornersections,theoffsetis
toohigh.
Correction amount
is too low, increase
the offset value.
(+1 to +5)
Adequate oset value. Correction amount
is too high, decrease
the offset value.
(-1 to -5)
Peelthetriangularsectionandtheremainingthinlycuttracesinthebackingsheetwillbejusttheright
cuttingforce.Incaseswherethebackingsheethasbeenfullycut,thecuttingforceistoohighorthe
bladelengthistoolong.Incaseswherecuttingtracesarenotpresentinthebackingsheet,thecutting
forceistooloworthebladelengthistooshort.
Peel the triangular section and the remaining thinly cut traces in
the backing sheet will be just the right cutting force. In cases
where the backing sheet has been fully cut, the cutting force is too
high or the blade length is too long. In cases where cutting traces
are not present in the backing sheet, the cutting force is too low or
the blade length is too short.
(5) PresstheF1key(TOOLCONDITIONS)andadjustthecuttingforce/correctionamount(offset)inthe
conditionsettingmenu.
(6) Repeatsteps(2)-(5)untilafavorablecuthasbeenachieved.
(7) Ifafavorablecuthasbeenachieved,presstheESCkeytoreturntoREADYstatus.