GRAPHTEC LABELROBO LCX603 - Page 65

LCX603-UM-651-9370 2-57
2 Setup
(8) PressthePOSITIONKey(
← →)
tomovecursortothecuttingspeedposition.
<1 0 9 U 0 1 4 30 2 >
[SPE E D]
SELE C T:
← →↑↓
YES: E NTER N O :ESC
(9) Setthe15forforcebyusingPOSITION(↑↓)Key.
(10)PressthePOSITIONKey(
← →)
tomovecursortotheaccelerationposition.
<1 0 9 U 0 1 4 15 1 >
[ACC E L]
SELE C T:
← →↑↓
YES: E NTER N O :ESC
(11) Setthe1foraccelerationbyusingPOSITION(↑↓)Key.
(12)PresstheENTERKey,

settingisstored.
(13)PresstheLOCALKey,toreturntoREADYstatus.
Conrming the cutting result by the test cutting
Performthetestcuttingaftertoolconditionwasset,andthenconrmthecuttingquality.
Conrmthemediaiscutenough.Conrmthecorneriscuttingcorrectly.
Adjustthetoolconditionifthecuttingqualityisbaduntilthecuttingqualitybecomesbetter.
How to perform the test cutting
(1) PresstheTOOLCOND.KeyinREADYstatus,thefollowingmenuisdisplayed.
T OOL C O NDI T I ONS>
TES T CUT>
CUT T I NG W I DTH>
(2) PresstheF2Key(TESTCUT),thefollowingmenuisdisplayed.
TEST CUT?
POSI T ION:
← →↑↓
YES: E NTER N O :ESC
PressthePOSITIONkeys(
← →↑↓
)movethetoolcarriagetothepositionwherethecuttingtestwill
becarriedout.
(3) PresstheENTERkeytocutatriangulartestpatterninthemiddleofthesquareinthecurrentposition.
Thebelowmessagewillappear.
T OOL C O NDI T I ONS>
TES T CUT>
CUT T I NG W I DTH>