GRAPHTEC LABELROBO LCX603 - Page 64

LCX603-UM-651-9370 2-56
2 Setup
Adjusting the tool condition
Thereareveitemsforthetoolcondition,whicharetooltype,bladeoffset,cuttingforce,cuttingspeed,
andacceleration.
Tooltype................. The09UisdisplayedontheLCD.TheCB-09UisacuttingbladefortheLCX603.The
CB-09UisusedfortheLCX603only.Thereforethetooltypeisnotselectableforthe
LCX603.
Bladeoffset............ Thebladeoffsetdependsonthemediathickness.Themostofmediaisnotnecessity
toadjustthis.Setthissettingto“0”.
Cuttingforce........... Thecuttingforcedependsonthehardnessofthemedia.Moreforceneedswhenthe
hardmediaiscutting.
Cuttingspeed......... Thecuttingspeedaffectstoqualityofcutting.Decreasethecuttingspeedtohavea
goodcuttingquality.
Acceleration........... Theaccelerationaffectstoqualityofcutting.Decreasetheaccelerationtohavea
goodcuttingquality.
How to adjust the tool condition
(1) Themediaof“FNSMatN50-1310B”isinstallingtotheLCX603.Setthe0forbladeoffset,the14for
cuttingpressure,the15forcuttingspeed,andthe1foracceleration.
(2) PresstheTOOLCOND.KeyinREADYstatus,thefollowingmenuisdisplayed.
T OOL C O NDI T I ONS>
TES T CUT>
CUT T I NG W I DTH>
(3) PresstheF1Key(TOOLCONDITIONS),thefollowingmenuisdisplayed.
<1 0 9 U 0 1 4 15 1 >
[CON D ITIO N NO. ]
SELE C T:
← →↑↓
YES: E NTER N O :ESC
(4) PressthePOSITIONKey(
← →)
tomovecursortotheoffsetposition.
<1 0 9 U 0 1 4 15 1 >
[OFF S ET]
SELE C T:
← →↑↓
YES: E NTER N O :ESC
(5) Setthe0foroffsetbyusingPOSITION(↑↓)Key.
(6) PressthePOSITIONKey(
← →)
tomovecursortothecuttingforceposition.
<1 0 9 U 0 1 4 15 1 >
[FOR C E]
SELE C T:
← →↑↓
YES: E NTER N O :ESC
(7) Setthe14forforcebyusingPOSITION(↑↓)Key.