GRAPHTEC LABELROBO LCX603 - Adjusting the Blade Length and the Tool Condition

LCX603-UM-651-9370 2-55
2 Setup
2.16 Adjusting the blade length and the tool condition
Adjusting the blade length
Ifthebladelengthisnotadjustedtottheutilizedlabelmaterials(media)andcutterblade,itwillnotbe
possibletoachieveanoptimalcut.Afteradjustingthebladelengthmanually,runatestcutandadjust
further.
(1) Adjustthebladelengthwithsamelevelofthetipofthebladeholderasshowninthepicturebelow.
Graduallyadjustthebladelengthtothethicknessofthelabelmaterialfromthe0length.
Blade
Media
(2) Extendthegraduallytothethicknessofthelabelmaterial.Abladelengththatislesserthanthe
thicknessofthebackingsheetmatchedtothelm,andgreaterthanthethicknessofthelmis
optimal.Trycuttingthelm,andadjustsothattherearecuttingtracemarksinthebackingsheet.If
thebackingsheethasbeencompletelycut,increasethebladelengthifitistooshortandthereare
remainingcutsinthelm.
Film
Backing sheet
Film thickness
Ideal blade length
Thebladelengthisadjustedbyturningthebladelengthadjustmentknob.Turnthebladeclockwise
tolengthentheblade;turncounterclockwisetoretract.Thebladeextendsap.0.1mmforevery
calibratedrotation.
B A
(Blade extends)
The cutter blade
moves 0.1 mm with
one scale unit
(3) Themediaof“FNSMatN50-1310B”isinstallingtotheLCX603.Haveabout0.1mmbladelengththis
time.(Turntheonescaleunitclockwisefromthe0mmbladelength.)
(4) Conrmthecuttingconditionbythecuttingtest.
Increasethecuttingforcealittleifthemediawasnotcutenough.
Increasethebladelengthalittleifthemediawasnotcutenoughafterthecuttingforceisincreased.
(Thebladelengthdoesnothaveenoughlengthtocutthemedia.Turnahalfscaleunitclockwiseto
haveenoughlengthtocutthemedia.)