GRAPHTEC LABELROBO LCX603 - Installing the Media to the Media Stocker

LCX603-UM-651-9370 2-23
2 Setup
2.11 Installing the media to the media stocker
Takeoutthemediaangefromtheaccessorybox,andthensetthemediatotheange.
(Theshaftofmediaangeislongerthanthelaminateange.)
(1) Settheangepositiontomatchtothemediawidth.
ThepreparedmediaisFNSMatN50-1310B.
Settheangepositionto130mmwidth.
(2) Unlocktheangelockplate,andthenslidetheleftangetottomediawidth.
Step 1:
Step 2:
Step 3:
Press the “PUSH”
part of the flange.
Slide up the flange lock plate.
Slide the flange to
fit to the media width.
(3) Settheleftangetothe130mmwidthposition.
Media width (mm)
130 70110
• • •
•
(4) Lockintheshaftgrooveandsettheange.
Step 1
Step 2