GRAPHTEC LABELROBO LCX603 - Setting the Registration Mark Type

LCX603-UM-651-9370 2-89
2 Setup
2.24 Setting the Registration Mark Type
Readtheprogrammedregistrationmarkinthecuttersectionandruncuttingtomatchtheregistration
mark.
Selectaxisadjustmentfrom"1POINT"and"3POINT".
Useaxisadjustment(tiltadjustment)anddistanceadjustmentinthefollowingmanner.
1POINT................... Adjustsfromdatastartingpoint(origin)positionfor1POINTadjustments.
3POINT.................. Adjustsin3aspectsoftheregistrationmarkfor3POINTadjustments:origin/x-axis
direction/y-axisdirection.
Theworktimeshortenswhentheregistrationmarksettingissetto1POINT,butthepositionadjustment
accuracyisinferiorcomparedto3POINT.Select3POINTwhenanaccuratepositionadjustmentis
necessary.
Feeding direction
1 Point
Feeding direction
3 Points
Origin registration mark
Not used in
reading (correction)
Origin registration mark
Y-axis registration mark
X-axis registration mark
Y
X
Y
X
How to set the registration mark setting
Conrmtheregistrationmarksettingissettothe3pointsthistime.
(1) PresstheLOCALKeyinREADYstatus,thefollowingmenuisdisplayed.
PR I N TER M ENU>
C U T TER M ENU>
O U TPU T ALL>
(2) PresstheF1Key(PRINTMENU),thefollowingmenuisdisplayed.
C OPY>
D A TA C L EAR>
C OND I T ION>
1/4
(3) PresstheNEXTKeyuntilthefollowingmenuisdisplayed.
RE G ISTR A T ION M ARK>
U N I T L E N GTH>
F U NCTI O N SE T T ING>
3/4