GRAPHTEC LABELROBO LCX603 - Distance Adjustment

LCX603-UM-651-9370 2-63
2 Setup
2.18 Distance Adjustment
Thisadjustmentshouldbeperformedafterthedifferentthicknessofmediawasinstalled.
Thedistanceadjustmentcompensatesforthelengthoftheplotlinegeneratedaccordingtothethickness
andtypeofthemediaused.Asforthedistanceadjustmentvalue,thelengthofthelineismeasuredand
entered.
Theadjustmentpatternisprinted,andthecorrectionvalueisenteredasthedistanceadjustment.
MeasurethedistancebetweencrossesprintedwithHead3(ribbon3),andenterthecorrectionvalueas
CorrectionValue=MeasuredValue-190mm.
Theadjustmentpatternoutputstwolayers.Measuretheprintingresults,andenterthecorrectionvalue.
Also,printingthedistanceremoveddatainthedirectionofthemediafeed,whensettingthedistance
adjustmentvalue,refertotheUserPatternCorrectionprintedbelow.
The130mmwidthmediahavetobeinstalledwhenperformingthedistanceadjustment.
Andtheinkribbonshavetobeinstalledforallprintheads.
Adjustment Pattern Instructions
Y
X
First page
Second page
Y
X
Head 1 (Ribbon 1): Blue
[Example]
Head 2 (Ribbon 2): Red
Head 3 (Ribbon 3): Black
Head 1 (Ribbon 1): Blue
[Example]
Head 2 (Ribbon 2): Red
Head 3 (Ribbon 3): Black
Printed with head 3
Printed with head 3
Printed with head 2
Measure the length
Measure the length
Printed with head 1
Feeding direction
Feeding direction
Wrinkle
prevention
lines
Wrinkle
prevention
lines
Print4crosssectionswithHead3.PrinttheconnectinglinesegmentwithHead1intherstlayer,and
Head2inthesecondlayer.