GRAPHTEC LABELROBO LCX603 - Page 70

LCX603-UM-651-9370 2-62
2 Setup
(12)AfterthecorrectionvaluesforboththeXdirectionandtheYdirectioninput,thenconrmthe
adjustment.
(13)PresstheF4Key(CUTCONFIRMATION),thefollowingmenuisdisplayed.
CONF I RM A D J UST M E NT?
YES: E NTER N O :ESC
(14)PresstheENTERkey,andthentheadjustmentconrmationcrosscuttingiscutonthe2ndpageby
thecutter.
Feeding direction
Page 5Page 1 Page 2
Confirm the variance on the page 2
X amount of variance
Correction input: -Y
X amount of variance
Correction input: -X
(15)Afterthecut,thefollowingisdisplayed.
POSI T ION A D JUS T M ENT
X-PO S I TIO N ADJ>
Y-PO S I TIO N ADJ>
C U T CO N F IRM A T ION>
(16)Conrmtheresultofthe2ndpage.Ifthereisgapbetweentheprintedcrossandthecutcross,then
repeatthestep(10)to(15).
(17)Ifthereisnogapbetweentheprintedcrossandthecutcross,thenpresstheLOCALKeytoexitfrom
theadjustment.