GRAPHTEC LABELROBO LCX603 - Installing the Cutter Pen; Preparing the Cutter Pen

LCX603-UM-651-9370 2-17
2 Setup
2.9 Installing the Cutter Pen
2.9.1 Preparing the Cutter Pen
 Whenhandlingthecutterblades,takefullcarenottocutyourhands.
Thenomenclatureandtypesofcutterpensareexplained.
Types of Cutter Blades and Their Features
ThefollowingcutterbladeandthePlungerareusedwiththeLCX603.
ModelName&Shape Diameter UtilizedPlunger Use&Features
CB09UA
0.9mm PHP32-CB09N-HS
Standardcutterforcuttingcoloredlm.
Thebelowcutisappropriateformediawith
athicknessunder0.25mm.
PossibleCuttingLength:App.4000m
Cutter Pen Part Names
Thecutterbladeissetandusedinthecutterplunger.Setandusethebladesinthesuitablecutter
plunger.
Cutter Blade
Plunger
Plunger cap
Blade length adjustment knob
(Fro Blue: ø 0.9 mm)
Installing the Blade to the cutter pen
(1) Installthespringtotheblade