GRAPHTEC LABELROBO LCX603 - Page 26

LCX603-UM-651-9370 2-18
2 Setup
(2) Installthebladewithspringtotheplungercap.
Cutter Pen Nomenclature
ø 0.9 mm Cutter Pen
Plunger cap
(Cross-Section)
Spring
Plunger
Blade lenght
adjusment knob
(Blue)
Plunger cap
ø 0.9 mm Cutter blade
(3) Installtheplungercapwiththebladeandthespringtotheplunger.
 Whenhandlingthecutterblades,takefullcarenottocutyourhands.
Adjusting the Blade Length
Thebladelengthmustbeadjustedtoprovidethemostappropriatecut.Runthetestcutseveraltimesand
setthemostappropriatebladelength.Thebladelengthvariesdependingonwhenthelaminateisused/
notused.
Thebladelengthisdifferentwhenthemediaislaminatedornotlaminated.
ThebladelengthshouldbeadjustedafterthemediawassettotheLCX603.
B A
The cutter blade
moves 0.1 mm with
one scale unit.
(Blade extends)
Thebladelengthisadjustedbyturningthebladelengthadjustmentknob.Toextendthecutterblade,turn
theknobintheAdirection.Toretractthecutterblade,turntheknobintheBdirection.Whentheknob
isturnedthedistanceofonescaleunit,thecutterblademoves0.1mm.Whentheknobisgivenonefull
turn,thecutterblademoves0.5mm.