GRAPHTEC LABELROBO LCX603 - When Send the Print Data Via the LAN

LCX603-UM-651-9370 3-6
3 Installing the Printer Driver
3.2 When send the print data via the LAN
SettheIPaddressandothersettingsfortheLANconnectionbeforeconnectingtheLCX603viatheLAN.
ThereforetheIPaddresshavetogetfromtheadministratorofnetwork.
The item to set up for the LAN connecting
•DHCPsetting
•IPaddresssetting
•Subnetmasksetting
•Gatewaysetting
•MACaddress(TheMACaddressmustbeusedbytheadministratorofnetworkwhentheLANwas
protectedbytheMACaddress.)
How to set up for the LAN connecting
(1) TurnonthepowerfortheLCX603.
(2) Thefollowingmenuisdisplayedwhenthemediaisinstalled.
Con r m Co m b ina t i on!
H3:x x xxxx H2: x x xxxx
H1:x x xxxx xxx x x xxxx
YES: E NTER
(3) PresstheENTERKey.
DHCP Setting
SettheDHCPsettingto"OFF".AndhaveaIPaddressfortheLCX603.TheIPaddressshouldbe
assignedbytheadministratorofnetwork.TheLCX603willbedisconnectedfromthenetworkwhenthe
DHCPserverwasreleasedtheIPaddressfordevicebytimesharingsetting.
ThereforethexedIPaddresshadbettertobeassignedfortheLCX603.
(4) PresstheLOCALKeyinREADYstatus,thefollowingmenuisdisplayed.
PR I N TER M ENU>
C U T TER M ENU>
O U TPU T ALL>
(5) PresstheF1Key(PRINTMENU),thefollowingmenuisdisplayed.
C OPY>
D A TA C L EAR>
C OND I T ION>
1/4
(6) PresstheNEXTKeyuntilthefollowingmenuisdisplayed.
L A N SE T T ING>
M A C AD D R ESS>
4/4