GRAPHTEC LABELROBO LCX603 - Page 29

LCX603-UM-651-9370 2-21
2 Setup
Notes on the Use of the FEED Key
Whensendinglabelmaterialsnormally,releasetheribbonlever.
Whenlabelmaterials(media)aresentwiththeFEEDkey,thelabelsthatarepartwaythroughprinting
cannotbecompletednormally.Ifthelabelspartwaythroughprintingneedtobecompleted,carryoutthe
“OUTPUTALL”operationinsteadoftheFEEDkey.
AftersendinglabelmediawiththeFEEDkey,carryouttheinitialtransfersystemactionpriortothenext
printing.Thelabelmaterials(media)canthenbesent.Becarefulastherewillbewastedandblank
labels.
Viewing the Screen
Thecontrolpanelscreendisplaysinformationrespondingtothesituationatthetime.
READY Screen
R E A D Y
C O N D I T I O N - 0 1
Displays the set condition number.
Printer Menu Screen
C O P Y >
D A T A C L E A R >
C O N D I T I O N >
1 / 4
P R I N T S E T T I N G >
P R I N T T E S T P A T T E R N >
H E A D A D J U S T M E N T >
2 / 4 P R I N T E D L E N G T H >
R E G I S T R A I O N M A R K >
U N I T L E N G T H >
F U N C T I O N S E T T I N G >
3 / 4
The “>” sign which is displayed
on the right-hand edge of the
Menu indicates that the item
has subordinate items in the
menu hierarchy assigned to
keys F1-F4.
The menu switches by
pressing the NEXT key
only in the print menu.
Load Number Selection Screen
L O A D N O .
< 0 1 >
S E L E C T : ↑ ↓
Y E S : E N T E R N O : E S C
The selected item is shown.
The setting value within
the “<>” can be changed.
Cutting Conditions Setting Screen
< 1 0 9 U + 1 1 4 3 0 2 >
[ T O O L T Y P E ]
S E L E C T : ← → ↑ ↓
Y E S : E N T E R N O : E S C
An “_” (underbar) is shown underneath
the selected cut conditions. The items
are shown below.
During Operation Screen
P R O C E S S I N G
5 4 / 1 0 0
The number of copies is shown.
(Present number/Total nuber)