GRAPHTEC LABELROBO LCX603 - Page 94

LCX603-UM-651-9370 2-86
2 Setup
(11) Releasetheribbonlever.
Ribbon lever
(12)Whentheribbonleverreleased,thefollowingmessagewillbedisplayed.
Con r m Co m b ina t i on!
H3=S e mi-R H2= R E SIN
H1=R E SIN
YES: E NTER N O : ESC
(13)PresstheFEEDkey,andalwaysmakesuretherearenowrinkleswhenfeedingthemediaandthat
thebackingsheetiswoundinthewinderbobbinwhenthelaminateisfed.
Whenthebelowmessageisdisplayed,releasetheribbonlever.
W04: L oadi n g ch e c l
Ribb o n le v e r i s set.
Can n ot f e e d.
YES: E NTER
(14)Readjustthecutterbladelengthandthecuttingforceafterthelaminateisinstalled.