GRAPHTEC LABELROBO LCX603 - Page 93

LCX603-UM-651-9370 2-85
2 Setup
(9) Pulloutthelaminate(Step1).
Cuttheadhesiveareaofthelaminateapproximately150mmfromtheforefront(Step2).
Cutandpeeltheadhesivesectionofthelaminatetip(Step3).
Step 2
Only cut the adhesive
part of laminate
Approx. 150 mm
Step 1
Step 3
(10)Applythelaminate(adhesivesection)straightoverthelaminatebarandlaminatetensionbartothe
media(Step1).
Foldbackthebackingsheetsidefromthelaminatetensionbarandattachtothelaminatewinder
bobbinwithtape(Step2).
Laminate tension bar
Laminate bar
Laminate
Laminete backing sheet
Step 2
Attach the laminate backig
sheet to the rewind bobbin
using the tape.
Step 1
Put the adhesive part
of laminate onto
the media.
Ifthelaminatebackingsheetisoverlysagging,twistthelaminatewinderbobbintowinditup.
Sincethereisarotationaldirectioninthelaminatewinderbobbin,refertothebelowpicturewhen
winding.