GRAPHTEC LABELROBO LCX603 - Page 75

LCX603-UM-651-9370 2-67
2 Setup
(18)PresstheF1key(ADJ.PATTERNPRINT),thefollowingmenuisdisplayed.
PRIN T ADJ U S TME N T
PATT E RN?
YES: E NTER N O :ESC
(19)PresstheENTERkey(Yes),andthecorrecteddistanceadjustmentpatternisprinted.
Afterprinting,themenureturnstotheREADYstatus.
READ Y
C ONDI T I ON- 0 1
(20)Releasetheribbonlever.
Ribbon lever
(21)Whentheribbonleverreleased,thefollowingmessagewillbedisplayed.
Con r m Co m b ina t i on!
H3=S e mi-R H2= R E SIN
H1=R E SIN
YES: E NTER N O : ESC
(22)PresstheFEEDKeyuntiltheprintedmediacomesoutfromtheexitareaoftheLCX603.
(23)MeasuretherstpageofXdistancebetweencrossesprintedwithHead3(ribbon3),andconrmthe
distancexwasadjustedtothe190mm.
(24)Theadjustmentisendifthedistancexwasadjustedtothe190mm.