GRAPHTEC LABELROBO LCX603 - Page 33

LCX603-UM-651-9370 2-25
2 Setup
(7) Installthemediatothemediastocker.
Withdrawthemediatipuptothestockertipandsetitexactlystraightalongthepositionscaleofthe
mediawidth.
However,besurenottogooverthetipofthemedia.
Set the media tip to be at this position.
Step 1
Step 3
Step 2
Gear
Position Scale
Positionscale
(8) InstallthemediastockertotheLCX603.
Withtheexceptionofreplacingmedia,donotpulloutthemediastocker.Ifthemediastockeris
pulledoutwhenitisset,themediamayloosenandprinterbandingmightoccur.