GRAPHTEC LABELROBO LCX603 - Page 50

LCX603-UM-651-9370 2-42
2 Setup
(4) SettheprintheadpressureselectorplatetotheRESINposition,fortheRESINinkribbonwas
installedinstep(2).
(5) SlidetheprintheadpressureselectorplatetotheRESINpositionasshowninthepicturebelow.
RESIN
Semi-R
RESIN
Semi-R
RESIN
Semi-R
RESIN
Semi-R
Semi-RESINRESIN
Head pressure
selector plate
Head pressure
selector plate
Stpper
Stpper
While pressing the stopper,
slide the head pressure selector plate up.
While pressing the stopper,
slide the head pressure selector plate down.
Conrm the print head pressure selector plate position when the ink ribbon was replaced.
(6) TakeouttheRESINinkribbonandtheribbonangesfromtheaccessorybox.
(7) Installtheinkribbonangetotheinkribbon.
(8) Settheinkribbonangetotheinkribbonasshowninthepicturebelow.
Whenpeelingthetape,becarefulnottopeelthelmsectionoftheribbon.
Cutout section
A
Printed side
Printed side
Ink ribbon flange
Not yet printed side
Not yet printed side