GRAPHTEC LABELROBO LCX603 - Page 51

LCX603-UM-651-9370 2-43
2 Setup
(9) Expandtheinkribbonasshowninthepicturebelow.
Not yet printed side
Printed side
(The side, which rolls the transparent part
when the ribbon is new)
(10)Puttheinkribboncassetteontotheexpandedinkribbonasshowninthepicturebelow.
Conrmtherewinddirectionofribbonissameasshowninthepicturebelow.
(11) Settheinkribbonandholdtheangesectionwhensettingit.Pushuntilthereisaclickingsound.
Setthecutoutsectionoftheinkribbonbobbinintothepositionshowninthebelowpicture.
Printed side
Set the cutout part of
bobbin to this side.
Not yet
printed side
Duringset-up,becarefulnottoconfusethesendingsidewiththewind-upside.(Whensetinthe
ribbonstocker,maketheareacomingtowardtheuppersidethewind-upside.)
Takecarenottoletdustintothecassettebarorribbon.Thesignicantpresenceofdustcanleadto
athermalheadmalfunction.Ifdusthassettledonthecassettebarorribbon,slightlywindthewind-
upside.