GRAPHTEC LABELROBO LCX603 - Page 45

LCX603-UM-651-9370 2-37
2 Setup
(28)PresstheENTERKeyafterthedancerroller1andthedancerroller2areinstalled.
TheLCX603startinitialization.
Thefollowingmenuisdisplayedduringinitialization.
When the separator function “ON” and the separator bobbin is not installed.
W18: M edia w ind e r
Set w inde r bob b i n
and p ress E NTE R . or
pres s F4 t o co n t inue
Theseparatorwillbesetlater,pressF4Keythistime.
When the laminate function “ON” and the laminate bobbin is not installed.
W09: N o la m i nat e
Load lami n a te!
Then pres s ENT E R . or
pres s F4 t o co n t inue
Thelaminatewillbesetlater,pressF4Keythistime.
When the separator function “OFF” and the separator bobbin is installed.
W19: M edia w ind e r
Remo v e wi n d er b o bbin
and p ress E NTE R . or
pres s F4 t o co n t inue
Theseparatorwillbesetlater,pressF4Keythistime.
When the laminate function “OFF” and the laminate bobbin not installed.
W10: l amin a t e i s ins-
tall e d. R e m ove i t!
Then pres s ENT E R . or
pres s F4 t o co n t inue
Thelaminatewillbesetlater,pressF4Keythistime.
(29)Thefollowingmenuisdisplayedafterthemediaisinstalled.
Con r m Co m b ina t i on!
H3=S e mi-R H2= R E SIN
H1=R E SIN
YES: E NTER N O : ESC
(30)PresstheENTERKeyatthistime.
Afterinitializationwasnished,followingmenuisdisplayed.
READ Y
C ONDI T I ON- 0 1