GRAPHTEC LABELROBO LCX603 - Page 73

LCX603-UM-651-9370 2-65
2 Setup
(7) Releasetheribbonlever.
Ribbon lever
(8) Whentheribbonleverreleased,thefollowingmessagewillbedisplayed.
Con r m Co m b ina t i on!
H3=S e mi-R H2= R E SIN
H1=R E SIN
YES: E NTER N O : ESC
(9) PresstheFEEDKeyuntiltheprintedmediacomesoutfromtheexitareaoftheLCX603.
(10)MeasuretherstpageofXdistancebetweencrossesprintedwithHead3(ribbon3),andenterthe
correctionvalue.
Y
X
Printed with head 3
Feeding direction
Correction value = 190.0 mm -measured value
Printed with head 2
Wrinkle
prevention
lines
Measure the length (measured value)
Forexampleintheaboveillustration,thecorrectionvaluebecomesnegativewhen“correctionvalue=
190.0mm-measuredvalue”andthemeasuredvaluewasmade190.5mm.(CorrectionValue:Input
as-0.5mm)