GRAPHTEC LABELROBO LCX603 - Page 91

LCX603-UM-651-9370 2-83
2 Setup
How to install the laminate
(1) Takeouttheangeandthelaminatestokershaftfromtheaccessorybox.
(Thelaminatestockershaftislongerthanthemediastockershaft.)
(2) Settheangepositiontomatchtothelaminatewidth.
ThepreparedlaminateisPET16-1110R4A.
Settheangepositionto110mmwidth.
(3) Unlocktheangelockplate,andthenslidetheleftangetottolaminatewidth.
Step 1:
Step 2:
Step 3:
Press the “PUSH”
part of the flange.
Slide up the flange lock plate.
Slide the flange to
fit to the media width.
(4) Settheleftangetothe110mmwidthposition.
Laminate width (mm)
110 5090
• • •
•
(5) Lockintheshaftgrooveandsettheange.
Step 1
Step 2