EN - 24
IMPORTANT: All references to left, right, front
or rear are given from the perspective of
operator in operator’s position, facing the
direction of forward travel.
EMERGENCY STOPPING
1. Move steering levers to neutral position.
2. Engage parking brake.
3. Push PTO knob down to off position.
4. Turn key switch to off position and
remove key.
BEFORE OPERATING UNIT
IMPORTANT: Register your product! See
Register Your Product! on page 1.
1. Check function of the Safety Interlock
System by performing the tests in Check
Safety Interlock System on page 29.
Contact an authorized Gravely EV dealer
for repair if any of the tests fail.
2. Check battery SOC and charge batteries
if necessary. See Check SOC on
page 32.
3. Ensure seat is in the operating position.
4. Ensure batteries are properly installed in
the machine. See Install Batteries on
page 34.
5. Ensure hood assembly is closed and
handle is securely latched. See
Figure 22.
6. Check battery balance. See Check
Battery Balance on page 31.
7. Set cutting height. See Figure 23.
d. Push mower lift pedal forward until
transport lock engages.
e. Insert height adjustment pin through
desired setting in height-of-cut
adjustment system.
f. Push mower lift pedal slightly forward,
release transport lock and slowly
release pedal until it contacts
adjustment pin and stops.
POSITION ROPS
IMPORTANT: Inspect ROPS and seatbelt for
damage and loose or missing hardware.
Raise Center Bar
See Figure 24.
1. Remove hairpins from lock pins and
remove lock pins from hinge plate.
2. Raise center bar and secure with lock
pins and hairpins.
OPERATION
WARNING: AVOID INJURY.
Read and understand the
Safety section before
proceeding.
WARNING: AVOID INJURY.
Seatbelt MUST be worn when
operating with center bar
raised.
Figure 23
1. Deck Lift Pedal
2. Height-of-Cut Adjustment System
1
2
To Next Page
Loading...
