EN - 31
CHECK FASTENERS
Check for loose or missing hardware.
LUBRICATE SEAT
See Figure 34.
1. Remove key and wait for moving parts to
stop and for hot parts to cool.
2. Move steering levers outward and pull
seat latch to rotate seat forward.
3. Apply grease to seat tracks through slots
under seat plate. See Figure 35.
4. Return seat to operating position and
slide seat back and forth to spread
grease along tracks.
CHECK MOWER BLADES
Check blades for wear and damage. Replace
or sharpen as needed.
CHECK BATTERY BALANCE
1. Remove key and wait for moving parts to
stop and for hot parts to cool.
2. Ensure batteries are installed in the
machine. See Install Batteries on
page 34.
IMPORTANT: If multiple batteries are
installed in the machine, they must be within
12% SOC to operate together.
3. Refer to the digital display. If battery
balancing is required, see Auto-Balance
Feature on page 32.
WARNING: AVOID INJURY.
Explosive separation of tire
and rim parts is possible.
• DO NOT inflate tires above
the recommended pressure.
• DO NOT inflate tires with a
compressor; use a hand
pump.
• DO NOT stand in front of
tire assembly when
inflating. Use a clip-on
chuck and extension hose
long enough to allow you to
stand to one side.
CAUTION: AVOID INJURY. Use
sturdy gloves or padding to
protect hands when working with
mower blades.
CAUTION: Unbalanced blades
cause excessive vibration and
eventual damage to unit.
Balance blades before
reinstalling on unit.
NEVER weld or straighten
blades.
To Next Page
Loading...
