EN - 39
WARNINGS
IMPORTANT: Warning codes do not require service or troubleshooting. Warning codes
display when unit is not within standard operating conditions.
IMPORTANT: See Fault / Warning Code Index on page 38 for fault and warning code details.
Location
0 = Other
1 = Left
2 = Center
3 = Right
Component
1 = VCM
2 = Battery
3 = Deck Motor
4 = Deck Controller
5 = Drive Motor
6 = Drive Controller
7 = Steering Sensor
Dealer Description Dealer Troubleshooting
02131 Battery reported one
battery discharge
mode.
Add another battery to the system if
operator wants to engage deck.
02132 Battery reported end
of life warning.
Battery is close to end of life.
02133 Battery reported end
of life.
Battery is at end of life.
02149 Battery reported end
of life warning.
Battery is close to end of life.
02150 Battery reported end
of life.
Battery is at end of life.
02165 Battery reported end
of life warning.
Battery is close to end of life.
02166 Battery reported end
of life.
Battery is at end of life.
02181 Battery reported end
of life warning.
Battery is close to end of life.
02182 Battery reported end
of life.
Battery is at end of life.
11065 VCM reported left
deck stall.
This warning displays when a deck
motor has stalled. Cycle PTO to
resume cutting. To troubleshoot:
1. Confirm phase wiring is
connected properly from motor
to controller.
2. Reduce cutting load by reducing
vehicle speed or cut height.
3. Verify machine is powered down,
check blade for obstruction or
material buildup on spindle or
blade.
13062 Left deck motor
overheating
warning.
1. Check motor and controller
phase wire connections for open
circuit.
2. Check to ensure blade rotates
freely.
3. Reduce cutting load.
4. Clean around debris around
motor and controller.
To Next Page
Loading...
