Grote 522 - Figure 15. Slice Gap and Slice Thickness Adjustment Bolts - Hydraulic Machines

Slicer/Applicator
SS-10.DOC:1/26/2007 11:08 AM Grote Company 22
First, loosen the two hex head bolts in the side of the thickness tray mounting assemblies. The slice
thickness tray pivot point can then be lowered or raised by turning the adjusting bolts located in the
top of the adjustment blocks. When the tray is at the desired height, it is parallel to the top surface
of the blade guide. Verify that the thickness tray is level at this height and tighten the hex head
screws on the side of the adjustment blocks.
Slice Gap Adjustment - Hydraulic Slicers
Adjust the slice gap, see Figure 17, using the following table, so that there is enough room between
the thickness tray and the blade guide for the slices to pass through. Some variance from the values
in the table may be necessary to obtain closer accuracy on very thin slices or to prevent thicker
slices from "hanging up" on the blade guide.
Figure 15. Slice Gap and Slice Thickness Adjustment Bolts - Hydraulic Machines
Figure 16. Slice Gap.
Slice thickness
adjustment bolt
Thickness
tray
Thickness tray mounting assembly
Blade guide
Hex head bolt
Slice gap
Slice gap adjustment
bolts