Slicer/Applicator
SS-10.DOC:1/26/2007 11:08 AM
Grote Company
36
Troubleshooting Charts
This section contains troubleshooting charts for use when the slicer is not operating properly. Go to
the chart that describes your trouble condition and follow the steps outlined on the chart. Charts 1-
11 deal with problems with getting the product to slice correctly. Charts 12-16 deal with problems
with machine operation.
Chart 1. Product Thickness Varies From Side to Side.
Chart 2. Product Thickness Varies From Front to Back.
Chart 3. Product Not Stacking or Laying Down Properly.
Chart 4. Excessive Product Scrap.
Chart 5. Product Slinging.
Chart 6. Product Curling or Twisting.
Chart 7. Product not Releasing or Cutting Cleanly.
Chart 8. Rough or Chafed Product.
Chart 9. Product Fracturing.
Chart 10. Product Tailing.
Chart 11. Product Not Slicing or Skipping.
Chart 12. Pump Won’t Run or Pump Pressure Low (Hydraulic Slicers).
Chart 13. Blade Won’t Run.
Chart 14. Pendulum Won’t Move.
Chart 15. Breaking Blades.
Chart 16. Won’t Count or Dead Space.
To Next Page
Loading...