Grote 522 - Chart 11: Product Not Slicing or Skipping

Slicer/Applicator
SS-10.DOC:1/26/2007 11:08 AM Grote Company 45
Chart 11: Product Not Slicing Or Skipping
Not Enough Product
In Product Holders
Product Not Slicing Or Skipping
Product Hung-up Or
Not Feeding Properly
Thickness Tray Not
Level From Front To
Back
Stop machine. Check product and tube sizes for proper fit.
Place a straight edge from blade guide to thickness tray
and reset thickness tray level from front to back at ground
zero.
Product Temperature
Too Low
Blade Guide Worn
Product holders must be at least 2/3 full.
Insure that product temperature is within proper slicing
range.
Use supplied gauge tools to check for wear. R
eplace blade
guide if required.
Blade Not Tracking
Correctly
Check blade and guide for
product residue. Check water
reservoir and water applicator pad if provided. Retrack
according to manual (See Page 29).
Slice Gap Not Set
Correctly
Reset slice gap according to chart in manual (See Page
26).