What does 'portX error' mean on my GSE Scales?
The 'portX error' on your GSE Scales means that the Model 675 did not check its receive data register in time, thus missing a character. To prevent this problem, try reducing the baud rate (P200).
What does 'frmgX error' mean on my GSE Scales?
The 'frmgX error' on your GSE Scales indicates that the stop bit of a received character did not occur when it was expected. This could be the result of an incorrect baud rate (P200), incorrect number of data bits (P201), or incorrect parity setting (P202).
What does 'ovrnX error' mean on my GSE 675 Scales?
The 'ovrnX error' on your GSE Scales indicates an overrun error occurred where additional characters were received while the receive buffer was full. The additional characters will be lost.
What does 'prtyX error' mean on my GSE 675?
The 'prtyX error' on your GSE Scales means that the parity of a received character did not match the parity specified in the setup mode at P202. This could also result if the baud rate (P200) or the number of data bits (P201) are incorrect.
What does 'CoDE95 SyErr Typ04' mean on my GSE 675 Scales?
The 'CoDE95 SyErr Typ04' error on your GSE Scales indicates an error occurred at startup. Contact GSE.
What should I do if my GSE 675 display 'CoDE95 SyErr HSR00'?
The 'CoDE95 SyErr HSR00' error on your GSE Scales indicates an error occurred at startup or during operation. Contact GSE.
What to do if my GSE Scales display 'CoDE08 Check Conn'?
This error usually indicates a defective or incorrectly wired load cell. Check the load cell and its wiring.
What does 'Press Enter' mean on my GSE Scales?
The 'Press Enter' message on your GSE Scales indicates that the key was pressed at a "pick instance" prompt. You must press K to select an instance, or to abort the instance entry.
What does 'Cksum error' mean on my GSE Scales?
The 'Cksum error' on your GSE Scales indicates that the Model 675 has detected an integrity issue with its firmware upon power-up. ReFlash the Model 675.
Why do my GSE 675 say 'CoDE16 CHECK JUMPR'?
The 'CoDE16 CHECK JUMPR' error on your GSE Scales means a programming operation was attempted while the program jumper is installed. Installing this jumper prohibits any programming changes.
Details the structure and purpose of the user manual.
Explains the formatting used for keystrokes and displayed messages.
Defines signal words and symbols for hazards and important notes.
Guidelines for connecting pluggable equipment to accessible sockets.
Specifies isolator requirements for permanently wired connections.
Instructions for safe handling and replacement of batteries to prevent explosion.
Advises against installing the unit near water as it is not a washdown unit.
Details DB9 connector pin assignments for connecting a remote scale.
Instructions for enabling and setting up the Quick Count application.
Details how to store and recall part numbers with average piece weight.
Explains how to access setup menus for the APW Lookup application.
Instructions for using the Quick Count method for parts counting.
Steps for sampling and counting parts using the APW Lookup.
Using the keypad for simple sample and count operations.
Important considerations and tips for performing calibration.
How to enter the calibration mode from the application menus.
Specific steps to access calibration from APW Lookup or Quick Count.
Introduction to the various calibration methods available.
Descriptions and remedies for operational errors like Under Load and Zero Max.
To Next Page
General
