GW Instek GPT-12004 - Manual Tests

GPT-10000 Series User Manual
40
Manual Tests
This section describes how to create, edit and run a single ACW,
DCW, IR, GB and CONT manual tests. Each Manual setting
described in this chapter only applies to the selected manual test – no
other manual tests are affected.
Each manual test can be stored/recalled to/from one of 100
memory locations. Each stored manual test can be used as a test
step when creating an AUTO test (page 104).
 Setting the Test Function → from page 41.
 Choose/Recall a Manual Test Number → from page 42.
 Creating a MANU Test File Name → from page 43.
 Setting the Upper and Lower Limits → from page 44.
 Setting the Test Time → from page 47.
 Setting the Ramp Up Time → from page 49.
 Setting the Ramp Down Time → from page 51.
 Setting the Test Voltage or Test Current → from page 53.
 Setting the Test Frequency → from page 55.
 Setting a Reference Value → from page 56.
 Setting an Initial Voltage → from page 57.
 Setting the Wait Time → from page 59.
 Setting the ARC Function → from page 61.
 Setting MAX HOLD → from page 64.
 Setting PASS HOLD → from page 65.
 Setting IR Mode → from page 66.
 Setting GND OFFSET → from page 68.
 Setting GB Contact → from page 69.
 Zero Check for the Test Leads → from page 71.
 Setting the Grounding Mode → from page 74.
 Setting Contact Check → from page 81.
 Setting IRMode Filter → from page 86.
 Screenshot Hardcopy → from page 86.
 Running a MANU Test → from page 92.
 PASS / FAIL MANU Test → from page 97.
 Special MANU Test Mode (000) → from page 102.
 Sweep Function → from page 104.