EasyManuals Logo

GW Instek PSU 100-15 User Manual

GW Instek PSU 100-15
211 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #105 background imageLoading...
Page #105 background image
CONFIGURATION
105
Setup Rear USB
Speed
Sets the rear panel USB speed or turns the rear
USB port off.
F-22
0 = Disable USB, 1 = Full Speed, 2
= Auto Detect Speed
GPIB Address
Sets the GPIB address.
F-23
0 ~ 30
GPIB
Disable/Enable
Enable or disables the GPIB port.
F-24
0 = Disable GPIB, 1 = Enable
GPIB
Show GPIB
available Status
Shows the status of the GPIB option port.
F-25
0 = No GPIB, 1 = GPIB is
available
SCPI Emulation
Sets the SCPI emulation mode. The emulation
modes allow you to emulate the remote commands
of legacy equipment that is used in a test
environment. Parameter 2, 3 and 4 are only
supported as use stand alone.
F-26
0 = GW INSTEK, 1 = TDK GEN,
2 = Agilent N5700, 3 = Kikusui
PWX, 4 = AMREL SPS
LAN Settings
Show MAC
Address-1~6
Displays the MAC address in 6 parts. This setting
is not configurable.
F-30~F-35
0x00~0xFF
LAN
Turns LAN on or off.
F-36
0 = OFF, 1 = ON
DHCP
Turns DHCP on or off.
F-37
0 = OFF, 1 = ON

Table of Contents

Other manuals for GW Instek PSU 100-15

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GW Instek PSU 100-15 and is the answer not in the manual?

GW Instek PSU 100-15 Specifications

General IconGeneral
BrandGW Instek
ModelPSU 100-15
CategoryPower Supply
LanguageEnglish

Related product manuals