GW Instek PSU 100-15 User Manual

PSU Series User Manual
104
Auto Calibration
Parallel Control
This function performs offset calibration for
parallel control. There must be a short between
each unit before starting the calibration. See page
77 for details.
F-16
0 = Disable, 1 = Enable, 2 =
Execute Parallel Calibration and
set to Enable
Measurement
Average Setting
Determines the level of smoothing for the average
setting.
F-17
0 = Low, 1 = Middle, 2 = High
Alarm Recovery
and Output
Status
Set the output status when OHP, FAN and AC-Fail
alarm be cleared.
F-18
0 = Safe Mode, 1 = Force Mode
Lock Mode
When the front panel is locked, the Lock Mode
function determines the behavior of the Output
key.
F-19
0: Lock Panel, Allow Output OFF
1: Lock Panel, Allow Output
ON/OFF
Interface Configuration Settings
USB / GPIB Settings
Show Front Panel
USB Status
Displays the front panel USB-A port state. This
setting is not configurable.
F-20
0 = None, 1 = Mass Storage
Show Rear Panel
USB Status
Displays the rear panel USB-B port state. This
setting is not configurable.
F-21
0 = None, 1 = Linking to PC

GW Instek PSU 100-15 Specifications

General

Brand	GW Instek
Model	PSU 100-15
Category	Power Supply
Language	English