GW Instek PSU 100-15 User Manual

PSU Series User Manual
158
Interface Configuration
USB Remote Interface
Configuration
USB
Configuration
PC side connector
Type A, host
PSU side
connector
Rear panel Type B, slave
Speed
1.1/2.0 (full speed/high speed)
USB Class
CDC (communications device
class)
Steps
1. Connect the USB cable to the rear
panel USB B port.
2. Change the Rear panel-USB (F-22)
setting to 2 (Auto Detect Speed) or
1 (USB Full Speed).
Page 112
Note
If you are not using the rear panel USB
device port, set F-22 to 0 (Disable USB).
Page 112
3. The RMT indicator will turn on when a remote
connection has been established.
RMT indicator
AV
VOLTAGE CURRENT
VSR LAN RMT ERR DLY ALM ISR M 1 M 2 M 3 RUN
C V C C

GW Instek PSU 100-15 Specifications

General

Brand	GW Instek
Model	PSU 100-15
Category	Power Supply
Language	English