H3C S1526 - 2.3 Save Configuration; 2.4 System

User Manual
H3C S1526 Smart Ethernet Switch Chapter 2
Web-based Configuration
2-7
2.2.5 User Session Timeout
If your session is inactive for a certain period of time after
you log in to the Web-based NMS, you will be automatically
logged out and the system will display the [Web-based NMS
Login] dialog box shown in
Figure 2-1. The changes you have
made to the configuration during your session, however, will
remain on the Web page. To resume your operation, you need
to log in again.
 Note:
The user session timeout time is 300 seconds.
2.3 Save Configuration
When configuring the switch, remember to save your
configurations timely in order to prevent the loss of
configuration information.
Click [Save Config] on the menu bar to enter a page as
shown in
Figure 2-3. Click <Save> and click <Yes> on the
confirmation dialog box. Then the configuration information of
the switch is saved to the EEPROM of the switch. The switch
will automatically load the newly saved configuration
information next time it reboots and any unsaved configuration
information will be lost.