H3C S1526 - Setting IP Addresses; Restoring Factory Default Settings

User Manual
H3C S1526 Smart Ethernet Switch
Chapter 3 Configuration Through
Console Port
3-7
3.2.2 Setting IP Addresses
Type 2 on the main menu to go to the IP address
configuration page. Set the IP address of the switch first, and
then the subnet mask, followed by the gateway IP address. The
system will return to the main menu after successful
configuration.
For example, set the IP address of the switch to
192.168.0.2, subnet mask to 255.255.255.0 and gateway IP
address to 192.168.0.1.
Select your choice (0-4):2
IP: 192.168.0.2
Subnet mask: 255.255.255.0
Gateway: 192.168.0.1
IP Configuration Completed
3.2.3 Restoring Factory Default Settings
Type 3 on the main menu. The system will prompt you to
restore the factory default settings. Type Y and press <Enter>.
The system will start restoring the factory default settings of
the switch, and will return to the main menu after the default
settings are successfully restored.