User Manual
H3C S1526 Smart Ethernet Switch Chapter 2
Web-based Configuration
2-26
Packet Description
Deferred error
The number of packets transmitted by a
port for which the first transmission
attempt is delayed because the medium
is busy.
Collisions error
The number of collisions experienced
by a port during packet transmissions.
Late collisions
error
The number of times a collision is
detected later than 512 bit-times into
the transmission of a packet.
Note:
Cyclic redundancy check (CRC) is a technology whereby to
check the errors of a data frame.
2.5.5 Rate Limit
With the rate limit enabled, the rate of packets coming into
or leaving the port will be limited, to ensure the smooth
operation of the network.
Click [Port/Rate Limit] to enter the [Rate Limit] page, as
shown in
Figure 2-17, where you can see the rate limit status
of each port. The symbol “--” indicates that no rate limit is
applied. Click a port number to enter the [Rate Limit
Configuration] page, as shown in
Figure 2-18, where you can
set the rate limit for the port.
To Next Page
Loading...
Need help?
General
