User Manual
H3C S1526 Smart Ethernet Switch Chapter 2
Web-based Configuration
2-17
Table 2-5 Port property item description
Item Description
Port
Number of the port currently being
configured.
Speed
Three options available: auto-negotiation, 10
Mbps, and 100 Mbps. For port 25 and port 26
there is one more option: 1 Gbps. If port
trunking is enabled on the port, the speed
cannot be changed.
Duplex
Three duplex modes available:
auto-negotiation, half duplex and full duplex.
Note that the duplex mode cannot be
changed if port trunking is enabled on the
port.
Admin
Sets the data forwarding status for the port. A
port cannot forward data if it is set to
“disabled”.
Priority
Priority of the port, raging from 0 to 7. Refer
to section
2.7.2 “QoS Configuration” for
details.
Flow control
Enables/disables the flow control function for
the port. This setting is available only when
the current port is set to “enabled”.
2.5.2 Trunk
I. Port trunking introduction
The port trunking feature allows you to set multiple ports to
one trunk group, so that the incoming/outgoing loads are
To Next Page
Loading...
Need help?
General
