EasyManuals Logo

H3C S3600 Series Installation Manual

H3C S3600 Series
98 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #58 background imageLoading...
Page #58 background image
Installation Manual
H3C S3600 Series Ethernet Switches Chapter 3 Installation
3-8
Note:
Guide rails purchased from H3C apply only to standard cabinets 1,000 mm (39.4 in)
deep. Use other supports to substitute for guide rails in the case of other cabinet
depths.
z Installation procedure
Follow these steps to install a switch into a 19-inch standard cabinet
1) Wear an ESD-preventive wrist strap and check the grounding and stability of the
cabinet.
2) Take out the screwed packed together with the front mounting ears and fix one end
of the front mounting ears to the switch, as shown in
Figure 3-3.
3) Install guide rails on the brackets on both sides of the cabinet with M5 self-tapping
screws.
Figure 3-11 is for reference only.
Figure 3-11 Install guide rails
4) Hold the two sides of the switch and slide it gently along the guide rails into the
cabinet until it is located in a proper position, as shown in
Figure 3-12. Ensure that
the bottom side of the guide rails and the switch are in close contact.

Table of Contents

Other manuals for H3C S3600 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the H3C S3600 Series and is the answer not in the manual?

H3C S3600 Series Specifications

General IconGeneral
BrandH3C
ModelS3600 Series
CategorySwitch
LanguageEnglish

Related product manuals