Set the printer DIP switches
1. Set the printer power switch to OFF.
2. Push and hold ONLINE, then switch the power switch to ON. Release the button when a printout
of the current settings starts.
3. Push ONLINE again. "DIP SW1" shows on the printout. This is a prompt to change DIP switch
1 (switches 1–8).
4. Enter the settings for DIP switch 1 (switches 1–8) in succession. Push ONLINE for on. Push
FEED for off. Refer to Table 7, Table 8
and Table 9.
The ONLINE light comes on to identify an ON entry. The OFFLINE light goes off to identify an
OFF entry. Make sure to enter a setting for all eight switches. The setup mode cannot be
cancelled after it is started.
5. After all eight switches have been set for DIP switch 1, a printout prompt asks whether to
continue or repeat the procedure for DIP switches 2 and 3 or save the current settings.
After the settings have been saved, a printout is made and the printer goes back to normal
operation. Do not turn the printer off while it is saving settings. Wait until “Dip SW setting
complete!” is on the printout before the printer power is set to off.
Table 7 Printer DIP switch 1 settings
Switch Setting Function
1 Off Serial input
2 On High print speed
3 On Auto loading enabled
4 Off Auto linefeed disabled
5 On Enabled setting
6 Off Print density
7 On Print density
8 On Print density
Table 8 Printer DIP switch 2 settings
Switch Setting Function
1 On 40-column printing
2 On Backup font enabled
3 On Normal characters
4 Off Zero = Slash
5 On International character set = USA
6 On International character set = USA
7 On International character set = USA
8 Off International character set = USA
Table 9 Printer DIP switch 3 settings
Switch Setting Function
1 On 8 data bits
2 Off Parity setting = Yes
16 English
To Next Page
Loading...
