Table 11 Sliding toolbar options (continued)
Icon Function Description
Diagnostics General—Monitor lamp use and test, change or replace lamps.
Diagnostic tests—Test the pump, 4–20 mA output, digital I/O, plumbing, RS232, RFID,
fan and touchscreen calibration.
Calibration—See the calibration dates.
Data review Review, print or export data.
Sign on or off If password security is enabled, users must use a password to make operation
changes. Log off to prevent access to system changes.
Note: If a user is signed on remotely, the user cannot be signed off locally. If a user is signed on
locally, the user cannot be signed off by a remote user.
Setup menu
Table 12 shows the options on the setup menu.
Table 12 Setup menu options
Icon Description
TOC Change the settings for the TOC operating mode. Refer to TOC operating mode configuration
on page 27.
System Change the system settings for the analyzer (instrument name, language, time, measurement
units, sounds, network and backlight). Refer to System configuration on page 29.
Alarms Change the settings for the digital output alarms. Refer to Configure the digital output alarms
on page 31.
Analogs Change the settings for the analog outputs. Refer to Configure the analog outputs
on page 33.
Printer Change the printer settings. Refer to Configure the printer settings on page 33.
Security Enable or disable security, data logging and/or encryption of exported data. Set password
expiration and auto logout. Add, change or delete user accounts. Show the audit trail. Refer to
Security configuration on page 34.
Bottles Change the auto acceptance and test completion criteria for bottle mode operations. Refer to
Bottle mode configuration on page 37.
Password Change the password of the user that is logged in. This icon is only enabled when security is
enabled.
CIP Set the conductivity threshold and CIP timeout value. Refer to Configure clean-in-place (CIP)
options on page 36.
AutoSampler Enter the autosampler model. Refer to Configure the auto sampler on page 36.
Factory Shows the factory settings which can only be changed by factory authorized users. Push the X
icon to show the factory settings (e.g., model number, serial number and factory calibration date)
or copy the oxidation buffers (3 maximum) to a USB flash drive.
22 English
To Next Page
Loading...
