3. Push SYSTEM.
4. Select the General tab.
5. Select an option.
Option Description
Instrument
Name
Enter the name that will be used for the analyzer by the system. Options: 1 to
13 alphanumeric or symbol characters (default = PAT700 + the serial number)
Note: The system will reboot when the instrument name is changed.
Location Enter the location of the instrument.
Language Set the language for all interfaces (default = English). For Japanese and Chinese
translations, this option is not available. The applicable language will be installed at the
factory.
Note: A change to the language setting changes the operating system setting in the
registry. When the system is rebooted, the new setting is used.
Set the date, time and units
Set the date, time, temperature units and conductivity units that show on the display.
1. Push << to show the sliding menu.
2. Push the SETUP icon.
3. Push SYSTEM.
4. Select the Display tab.
5. Select an option.
Option Description
Date/Time Push Set Time. Use the arrow keys to enter the date and time.
Time Format Set the time format (default = 24-Hour).
Temperature display Set the temperature units (default = Deg. C).
Conductivity display Set the conductivity units (default = µS/cm U = uncompensated conductivity).
Configure the alarm sounds
Select the alarm sound for each alarm type.
1. Push << to show the sliding menu.
2. Push the SETUP icon.
3. Push SYSTEM.
4. Select the Sound tab.
5. Select a sound for each alarm type. Push the speaker icon to hear the selected sound.
6. Push the volume slider to set the speaker volume.
Configure the network settings
1. Push << to show the sliding menu.
2. Push the SETUP icon.
3. Push SYSTEM.
30 English
To Next Page
Loading...
