100 6LE005550A
Starting, commissioning, operation
4.6 Start-up and configuration via the HTD210H display
4.6.5
Configuration
recommendations
via HTD210H
Consult the user manual for the HTD210H panel display beforehand to read the
advice and instructions for using the product.
Energy circuit breaker protection setting
Before using the HTD210H display to configure the Energy circuit breaker protection
level, it is necessary to set the max Ir setpoint on the Energy circuit breaker.
Refer to § 4.2.3 page 81.
All the protection setting parameters can be modified from the Protection menu.
HTD210H panel display protection menu
Note
Certain protection parameters may or may not be available depending on the
Energy circuit breaker model. In particular, the ZSI sub-menu is only available
on an Energy P250 and above circuit breaker.
Setting the Energy circuit breaker measurement parameters
The measurement parameter settings can be accessed in the Configuration menu.
To Next Page
Loading...
