Hameg HM8118 Manual

35
Subject to change without notice
Important hints
howeversufcientventilationmustbeensured.Operationfor
extended periods of time requires the horizontal or tilted (hand-
le)position.Nominalspecicationsarevalidafter30minutes
warm-upat23°C.Specicationswithouttolerancesaretypical
values taken from average production units.
1.7 Warranty and Repair
HAMEG instruments are subjected to a strict quality control.
Prior to leaving the factory, each instrument is burnt-in for 10
hours. By intermittent operation during this period almost all
defects are detected. Following the burn-in, each instrument is
testedforfunctionandquality,thespecicationsarechecked
in all operating modes; the test gear is calibrated to national
standards.
The warranty standards of the country in which the instrument
was sold, are applicable. Reclamations should be directed to
the dealer.
Only valid in EU countries
In order to speed reclamations customers in EU countries may
also contact HAMEG directly. Also, after the warranty expired,
the HAMEG service will be at your disposal for any repairs.
Return material authorization (RMA):
Prior to returning an instrument to HAMEG ask for a RMA
number either by internet (http://www.hameg.com) or fax. If
you do not have an original shipping carton, you may obtain
one by calling the HAMEG service dept (+49 (0) 6182 800 500)
or by sending an email to service@hameg.com.
1.8 Maintenance
Before cleaning please make sure the instrument
is switched off and disconnected from all power
supplies.
Clean the outer case using a dust brush or a soft, lint-free dust
cloth at regular intervals.
No part of the instrument should be cleaned by the
use of cleaning agents (as f.e. alcohol) as they may
adversely affect the labeling, the plastic or lac-
quered surfaces.
The display can be cleaned using water or a glass cleaner (but
not with alcohol or other cleaning agents). Thereafter wipe the
surfaceswithadrycloth.Nofluidmayentertheinstrument.
Do not use other cleaning agents as they may adversely affect
the labels, plastic or lacquered surfaces.
1.9 Line fuse
The instrument has 2 internal line fuses: T 0.8 A. In case of a
blown fuse the instrument has to be sent in for repair. A change
of the line fuse by the customer is not permitted.
1.10 Power switch
The instrument has a wide range power supply from 105 to
253V,50or60Hz±10%.Thereishencenolinevoltageselector.
Fusetype
Size 5 x 20 mm; 250V~, C; IEC 127; Bl. III; DIN 41 662 (alterna-
tively DIN 41 571, Bl. 3). Slow blow T 0.8 A.

Hameg HM8118 Specifications

General

Brand	Hameg
Model	HM8118
Category	Measuring Instruments
Language	English