Wireless AP Router HNW300APN2
User Manual 62
WEP + Encryption Key
WEP aims to provide security by encrypting data over radio waves so that it is protected as it is transmitted
from one end point to another. However, it has been found that WEP is not as secure as once believed.
1. From the Encryption drop-down list, select WEP setting.
2. From the Key Length drop-down list, select 64-bit or 128-bit setting.
3. From the Key Format drop-down list, select ASCII (5 characters), Hex (10 characters), ASCII (13
characters) or Hex (26 characters) setting.
4. Enter the Encryption Key value depending on selected ASCII or Hexadecimal.
5. Click Apply Changes button.
6. Cliccate su OK.
7. Change setting successfully! Click on Reboot Now button to confirm.
To Next Page
Loading...
Need help?
General
